This is the notes for the upcoming Getting Started with MicroPython Tutorial at LinuxConfAU 2018 which aims to introduce people to the very basics of MicroPython in an easy and accessible way.
|10:45||Introduction (Nick Moore / Damien George)|
|10:55||Hands on: Installing, the REPL, I/O|
|11:40||Hands on: Networks, Libraries, Building from source|
|12:15||Developing on MicroPython (Nick Moore)|
|12:25||Lunch / More hacking|
The examples apply as far as possible to both the ESP8266 and the ESP32 ports of MicroPython.
I’ll have a limited number of ESP8266-based “Witty Cloud” boards along at the tutorial. You can purchase one of these for $10 as part of your LinuxConfAU registration (under “Extras”). If there’s any still available after ticket sales close then it’s first-come-first-served cash only at the start of the tutorial.
Please provide your own MicroUSB cable (surely everyone has a pile of these?) and any dongles your computer needs to talk to it!
If you have your own ESP8266 or ESP32 development board to bring along, perhaps from the PyConAU MicroPython Sprint or from one of the many vendors out there, you’re welcome to bring that along.
Clone this repo, install Python 3.6 and esptool (see Installing), if you have your own hardware confirm that you can see the serial device at least.
As above, plus read Building and follow along until you can’t follow any more. Downloading the toolchain and SDKs ahead of time will save a lot of time on the day.
If you picked up a Witty Cloud module for the tutorial, start here:
If you were at the Open Hardware MiniConf and got a LoliBot, start here:
Otherwise, there’s more general stuff in the following sections …
There’s a tutorial in the official MicroPython / ESP8266 docs at https://docs.micropython.org/en/latest/esp8266/esp8266/tutorial/index.html